Tape Measure

ABS - Active Braking System automatically locks the blade in place. Non-slip moulded Rubber case. Non-reflective steel blade. Triple riveted sliding end hook with magnet and rubber grip. 19mm wide blade can be extended without support over a distance of 1.7m. Secure belt clip. With stud marking every 16" on inch marked blades.

Tape Measure with ABS

Plastic Oil Cans

One piece moulded plastic bodies with positive force feed pumps, supplied with nylon push fit spouts.

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

Lever Type Cable Cutter

These cable cutters have heat treated cutting edges and are designed to cut copper/aluminium cables with minimal distortion. The soft grip handles are designed for user comfort whilst exerting force.

1" Square Drive Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

Metric

1? Drive Metric, Standard Length, 6-Point
Conform to: DIN 3129.

Kennedy Crowbars, Wrecking bars and Pry bars

Manufactured from carbon steel. These traditional designs are used by tradesmen in all industrial environments. Suitable for a wide range of general duty applications, ideal for dismantling timber constructions, opening packing cases and removing nails (depending on the type of bar). Also used in assembly applications offering safe leverage and alignment capability.

Line Type Pry Bar Set (2 Piece)

The Line angled blade provides greater leverage, ground points used by Steel Erectors & Scaffolders for aligning bolt or rivet holes.

2 piece set contains:
1x 400mm.
1x 600mm.

Drain Test Bung

Used to pressure test or temporarily seal the end of an open pipe which is newly laid or decomissioned, preventing the ingress of water, gasses, rodents.

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

Kennedy® Mains Testers

With heavy duty one-piece moulded insulation sheaths covering both blade and transparent plastic handle for extra protection and safety. Will detect 'live' electricity supply. Suitable for AC to 125 -250 volts. 3mm wide tip. Conform to VDE 0630 Part 4.

Ball Driver L-Wrenches

Manufactured from fully hardened carbon steel in accordance with DIN 911. A quality ductile key with precision cut ends and accurate AF dimensional to ensure maximum socket contact. Ball end allows up to 30 work offset. Long arm end is ball drive and short arm end plain. Black oxidised finish.