Kennedy® Straight Shank Hollow Punches

Manufactured from hardened carbon steel. Through body ejection of the punched material makes them ideal for punching clean edged holes in leather, wood, plastics, card and paper.

1" Square Drive Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

A/F

1? Drive Inch Size, Standard Length, 6-Point
Conform to: SAE, USA Federal Standard GGG-W-660A.

Replacement Case for Kennedy Socket Set (KEN-582-7983K)

Contents not included

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Diamond Point

Used for squaring out corners in keyways and cutting V shaped grooves in steel.
Cutting angle should be 40 - 50 to the vertical.

Open Jaw Slogging Wrenches

Manufactured to DIN 133.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.

Kennedy® Double-Ended Scriber

Used for the marking out of fine lines on metals. Manufactured from hardened and tempered high grade steel with knurled bodies for high grip and precision ground points for accurate marking. Available with a chisel point, pocket type, machinist's standard type, double ended, which are mainly used in conjunction with surface gauges.



Double ended, ideal for marking out in hard to get places eg. grooves. Overall length: 180mm.

Locking C Clamps

Wide and deep jaw profile, clears obstacles to firmly clamp sections that a normal grip wrench cannot.

Kennedy® Standard Industrial Terminals - Red Fork

Durable low cost copper or brass connectors. Manufactured as single piece connectors. Electro tinned to protect from corrosion. Insulated with flared entry, colour coded vinyl sleeves. All disconnect terminals supplied with anti-vibration copper sleeve.

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

Kennedy Hexagon Key L-Wrenches

Manufactured from fully hardened carbon steel in accordance with ISO 2936 and DIN 911. A quality ductile key with precision cut ends and accurate AF dimensional to ensure maximum socket contact.

The Ball end will work up to an angle of 30 offset to the head of the hex socket bolt. The long arm end has the ball drive and short arm length has a plain hexagonal end. Black oxidised finish.

Hexagon Key L-Wrench 9 Piece Ball Driver Set 5/64" to 3/8"

Kennedy hexagon key L-wrench ball driver sets are supplied with plastic storage clip with the sizes marked, making it easier and faster to locate the size of hex key you require.