567 Master Pipe Sealant

Low strength thread sealant with high lubricity to prevent galling on stainless steel fittings. (Should be used with activator 7649).

Recommended for all coarse metal threads where slow cure is required to prolong time frame for adjusting valves and fittings.
Temperature Range: -55C to 205C
AGA Approval No. 3207 to 1050kPa (152psi).

Loctite 415 - General-Purpose Instant Adhesive

Loctite 415 a high viscosity cyanoacrylate, general-purpose adhesive and is particularly suited to bonding of metals, rubbers and plastics. Available in 20g, 50g and 500g.

7200 - Chisel Aerosol

Removes all types of old gasket in minutes. No scraping, grinding or heating.

Loctite 403? Prism Instant Adhesive

Loctite 403? Prism High viscosity, low odor/low bloom, surface insensitive, one part room temperature cure, instant adhesive designed for applications with high cosmetic appearance and/or where vapor control is difficult.
Health and Safety friendly.

Loctite 272 High Temperature Threadlocking Compound

Loctite 272 High Temperature High Strength Threadlocking Compound



Designed for the permanent locking and sealing of threaded fasteners. Cures when confined in the absence of air between close fitting metal surfaces and prevents loosening and leakage from shock and vibration. Typical applications include the locking and sealing of large bolts and studs (M25 and larger).

Loctite 403? Prism Instant Adhesive

Loctite 403? Prism High viscosity, low odor/low bloom, surface insensitive, one part room temperature cure, instant adhesive designed for applications with high cosmetic appearance and/or where vapor control is difficult.
Health and Safety friendly.

Loctite 406 - Prism Cyanoacrylate Adhesive

For rubber, plastics, EPDM, nitrile and neoprene. Replaces 495, 414 and 424. Use with Polyolefin Primer 770 for difficult to bond plastics and rubber such as polypropylene, silicone etc. Available in 20g, 50g and 500g. Maximum operating temperature: 120°C.

Fast Cure Structural Adhesive (Pk-10)

Fast cure structural adhesive that combines clarity, toughness and excellent adhesion to plastics, metals and composites. 50ml syringe with static mixer for a controlled and accurate mix ratio.

Handling strength <3mins
Gel time - Approximately 1 min
Gap Fill - 2-3mm
2 part Acrylic Technology - cures quickly
Excellent bond strength and toughness on a wide range of substrates
50ml syringe with static mixer for controlled accurate mix ratio

Instant Adhesive

General purpose, for metals.

496 Medium Viscosity.