16mm Spigot End Fittings

Inch

Open End

1" Square Drive Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

A/F

1? Drive Inch Size, Standard Length, 6-Point
Conform to: SAE, USA Federal Standard GGG-W-660A.

Neodymium Pot Magnets

Neodymium magnet in a cylindrical brass pot. Assembled with steel pole pieces to give a multi-pole effect which offers superior grip at the contact face ideal for clamping or lifting application. Ideally work at temperatures upto 80°C, but have a maximum working temperature of 100°C

Shallow with Thread

Chain Pipe Vice

Used for repetitive pipe work. High tensile steel chain is looped over the pipe, locked into position and then tensioned by the handle and screw which secures the pipe. SG ductile cast iron frame drop forged steel jaws.



181C Bore: 90mm. Pipe ? 1/8? - 2?.
182C Bore: 150mm. Pipe ? 1/4? - 4?.
183C Bore: 220mm. Pipe ? 1/2? - 8?.

Replacement Case for Kennedy Socket Set (KEN-582-7983K)

Contents not included

Moving Edge Safety Knives

Lightweight, high performance disposable safety knife with built in tape cutter and ergonomic handle. Extremely durable design ideal for retail stores, light distribution duties, and emergency services. The body has a breaking force of 64kg and easily outperforms similar products. Suitable for cutting shrink wrap, plastic banding bags and tapes.
Overall length: 170mm.

Safety Knife

Replacement Smoothing Plane Irons

Suitable for bench planes.

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Diamond Point

Used for squaring out corners in keyways and cutting V shaped grooves in steel.
Cutting angle should be 40 - 50 to the vertical.

3/8" Square Drive Bi-Hexagon Sockets

Used most often in the automotive and aerospace industries. The weight to strength ratio ensures the reliability and accessibility that is so important in this type of production environment. Manufactured from chrome vanadium steel hardened, tempered, chrome plated and polished for corrosion protection. All have a ball-retaining groove on each face of the square drive, which ensures a positive fit with all accessories. Chamfered leading edge ensures easy fastener location.

Metric Deep

Bi-Hexagon sockets - 12 point - side drive design gives a higher torque than normal sockets, grip worn nuts and will not round off existing nuts. All have a ball-retaining groove on each face of the square drive, which ensures a positive fit with accessories. Requires only a one-twelfth turn to engage the next point of the socket

Open Jaw Slogging Wrenches

Manufactured to DIN 133.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.