Ring Slogging Wrenches

Manufactured to DIN 7444.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.

Volt Stick

Used for checking the presence of an AC voltage, locates break in cables, detects blown fuses and distinguishes between live and neutral wires in both single and three phase supply, without making any disconnection in cables, wall sockets etc. Volt Stick has a sensitivity of up to 4mm distance of a 2,5mm conductor carrying 220 - 400V. Note: The Volt Stick is for use on 50Hz supply only.

Senator® Broad Heel Brick Trowel

Ground polished, hardened and tempered high carbon steel alloy blades, tapered to remain rigid right to the tip with high angle handles for improved knuckle clearance and control. Chromed ferrules hold the forged tang firmly.



11" heel width. London pattern, a smooth rounded end wooden handle with integral tang.

Gardeners Kneeling Pad.

Designed for ease of use and user comfort, lightweight and durable with single grab handle. Manufactured from easy to clean water-resistant dense EVA foam, 18mm thick. Dimensions: 180 x 406 x 18mm. Weight: 121g.

Kennedy Short Ratchet Combination Spanner Set

Manufactured from hardened chrome vanadium steel with a polished mirror finish. Conform to: ANSI B107.6.

Metric (9 Pieces)

Contents:
10, 11, 12, 13, 14, 15, 16, 17 and 19mm.

3/8" Square Drive Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

Metric

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Cross Cut Chisels

Used for cutting keyways or flat bottomed grooves in blocks of steel or on steel shafts. The cutting edge is wider than the blade to give clearance in work and prevent jamming.

CV Ball Driver

Manufactured from chrome vanadium steel with a nickel plating. Manufactured to ISO2936 (formerly DIN 911L).
Set supplied in an indexed plastic holder.
Individual hexagon key slots help to instantly identify missing drivers.

Feeler Stock Coil

This handy product is housed in convenient rewindable dispenser rolls. Having the thickness stock in a case makes it very useful for cutting off the required length for adjusting tappets, spark plugs, distributor points, checking bearing clearances and gear play, fitting pistons, rings and pins, gauging narrow slots, etc. The stock is also useful for shimming in fixture and die work. Supplied in a compact, sturdy plastic rewindable dispenser case. Rewind feature, minimises accidental damage. Made of the finest tempered steel, marked every 6" or 150mm with a line, thickness in thousandths of an inch or in hundredths of a mm. The case provides the ability to snip off the desired length without any waste.

1/2" x 25ft

Drawers for the 1200 Series Cabinets

Dividers sold separately