Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

Kennedy Professional Insulated Screwdrivers

These Kennedy Professional insulted screwdrivers are a 2-in-1 design - use the detachable swivel cap for fast (low torque) driving, or use the full size detachable ergonomic handle for higher torque fastening. Fully insulated ergonomically designed handles, swivel cap and eight interchangeable drivers supplied in a compact protective pouch with belt loop. Safe up to 1000V AC/1500V DC.

Tested to international standards.
EN6090: 2004.
DIN EN 60 90:2005-01.

Insulated Screwdriver 10 Piece Set

Set Contains:
Main Handle.
Detachable swivel cap.

Parallel Drivers:
0.4 x 2.5 x 100mm.
0.5 x 3.0 x 100mm.
0.8 x 4.0 x 100mm.
1.0 x 5.5 x 100mm.
1.2 x 6.5 x 100mm.

Cross Points:
No. 0 x 100mm.
No. 1 x 100mm.
No. 2 x 100mm.

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

Open Jaw Spanners

Made from forged and hardened steel. Conform to DIN 894.

Single Ended

Industrial Combination Spanners

Manufactured from chrome vanadium steel with a satin finish body and highly polished heads. 15 open jaw angle to shank and ring end offset.
Conform to:
5.5mm - 25mm, 1/4" - 1" AF - DIN 3113.
26mm - 95mm, 11/16" - 2" AF - ASME B107.6.
1/8" - 1/2" Whitworth - DIN 3113 & BS192:1982.
9/16" - 7/8" Whitworth - ASME B107.6 & BS192:1982.

Metric

Nut Splitters

Mechanical drop forged, hardened and tempered plated steel. Ideal for releasing seized/damaged nuts etc.

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

1/4" AF Hexagon 'Direct Drive' Screwdriver Bits

1/4" Hex with ball recess.

Crosspoint

Kennedy® Butane Soldering Iron

BS050
Flint type ignition which is built into the cap. Uses standard butane lighter fuel and is simple to refill. Fully adjustable tip temperature control with a safety fuel cut-off when cap is replaced. Textured anti-slip barrel. Supplied with pointed soldering tip. Can be used with double flat, hot air, flame and hot knife, can also be used as a blow torch. Supplied without fuel.

Power rating: 50W.
Soldering temperature: 375°C.
Run time: 60 minutes.
Overall length with cap: 195mm.
Overall length with soldering tip: 180mm.

Mini Pipe Cutter

Compact and robust construction ideal for use in confined spaces. Grooved rollers allow close-to-flare cuts. Large feed screw for accurate cutting of aluminium, brass, copper and steel tubing. Length 66mm.