SCRIBER POINT

SCRIBER POINT FOR KEN518-4330K

Reversible Ratchet Ring Wrenches

For use where access is limited. With a built-in ratchet mechanism to provide speed and a reversible action which can be achieved by depressing the reversing lever or by simply turning the wrench over. All ratcheting ring wrenches are manufactured from chrome vanadium steel bi-hex rings.

25 Offset

Metric *Single hexagon

Industrial Combination Spanners

Manufactured from chrome vanadium steel with a satin finish body and highly polished heads. 15 open jaw angle to shank and ring end offset.
Conform to:
5.5mm - 25mm, 1/4" - 1" AF - DIN 3113.
26mm - 95mm, 11/16" - 2" AF - ASME B107.6.
1/8" - 1/2" Whitworth - DIN 3113 & BS192:1982.
9/16" - 7/8" Whitworth - ASME B107.6 & BS192:1982.

Whitworth

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

Sledge Hammers

Double faced sledge hammers are fully forged and heat-treated. Ideal for use on spikes, stakes, cold chisels and hardened nails. They are available with a hickory or fibreglass shaft.

Hickory Shaft BS 876.

Tested to the requirements of BS 876: 1981 (head stamped BS 876).

Kennedy Tin Snips

Kennedy straight blade tin snips are a traditional design, suitable for the general purpose cutting of sheet metal in a wide range of materials such as copper, aluminium and mild steel.

Manufactured from drop forged carbon steel with hardened and precision ground blades which can be re-sharpened.

Available in a range of sizes:

Straight Tin Snips

Eye Loupes

Manufactured from shock resistant plastic. Shatterproof lens. Ideal for jewellers, watchmakers, electronics and model makers.

Ring Slogging Wrenches

Manufactured to DIN 7444.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.

1/4" AF Hexagon Drive Screwdriver Bits

All Kennedy screwdriver bits have a hardness of 58 - 62HRC. High alloy chrome molybdenum steel for use on hand and power tools.

Tamperproof Torx

For repair and servicing on electronic, electrical and mechanical equipment.

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.