Mini Roller Sleeves

100mm (4") medium pile sleeve for emulsion and foam sleeve for gloss paint and varnishes, to fit mini rollers and radiator rollers.



Suitable for emulsion, vinyl silk and vinyl matt exterior paints and masonry paints on very rough surfaces such as stucco, concrete, brickwork, light pebble dash and textured surfaces.

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Brick Bolster

Suitably hardened for the purpose of splitting and cutting brickwork or stone smoothly and cleanly. Do not use as a lever.

Kennedy Impact Drive Sockets

Kennedy 1,1/2" square drive impact sockets are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings.

1,1/2" Drive Metric Size, Standard Length, 6-Point
Conform to: SAE, USA Federal Standard GGG-W-660A.

1,1/2" Impact Drive Sockets

Kennedy Air Line Tyre Inflators

This heavy-duty push on inflator is of rugged construction and has a clearview integral pressure gauge reading from 10 - 120psi. Heavy-duty corrosion-resistant body with brass fittings. 300psi rated fibre reinforced rubber hose. Accuracy conforms to EC Directive 86/217/EEC. Reading scale 2psi/50kPA (0.5 bar). Inflation range 120psi/800kPa (8 bar).

Heavy Duty Air Line Tyre Inflator with Gauge

Open Jaw Spanners

Made from forged and hardened steel. Conform to DIN 894.

Single Ended

Kennedy® Ferrite Shallow Pot Magnets

Manufactured from ceramic ferrite material. Suitable for holding machine tool accessories with M6 threads or building into jigs. Supplied complete with heavy-duty J bolt.

Replacement Squares for Torque Wrenches

To suit Kennedy Fixed Head Torque Wrenches

Kennedy Chrome Finish Adjustable Wrench Service Kits

Consist of replacement jaw, knurl and pin.

Kennedy® Standard Industrial Terminals - Red Connector

Durable low cost copper or brass connectors. Manufactured as single piece connectors. Electro tinned to protect from corrosion. Insulated with flared entry, colour coded vinyl sleeves. All disconnect terminals supplied with anti-vibration copper sleeve.

Ring Slogging Wrenches

Manufactured to DIN 7444.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.