Chrome Molybdenum Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

AF Deep

3/4? Drive Inch Size, Deep Length, 6-Point
Conform to: SAE, USA Federal Standard GGG-W-660A.

1/4" AF Hexagon Drive Screwdriver Bits

All Kennedy screwdriver bits have a hardness of 58 - 62HRC. High alloy chrome molybdenum steel for use on hand and power tools.

Crosspoint

External Spring Calipers

Manufactured from high quality polished steel with ground finished points. A circular spring bow joins the legs and a fine adjusting screw is mounted across the legs and is used for setting the distance between the two points. Calipers are used for taking internal and external measurements, also for comparing distances or sizes.

16mm Spigot End Fittings

Metric

Flare End

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Fluted Plugging/Seaming Chisel

For removing cement and mortar from between bricks and blockwork to either insert a wooden plug for nailing and screwing or to remove a brick for the placement of an air gate. The cutting edge is wider than the blade for clearance and the fluted blade speeds the removal of spoil.

Cylinder Hone Stones

Replacement cylinder honing stones 29 x 4.5mm, to suit Kennedy cylinder hones KEN5032940K and set KEN5032930K. Also compatible with most other leading brands. Pack of 3.
Packaging dimensions: (W x H x D): 89 x 100 x 20mm
Gross weight: 22g

WHS Brick Trowels

Blades manufactured from roll forged hardened and tempered high carbon alloy steel, polished and ground finish. With protective lacquer to inhibit rust. Angled handle for balance, control and improved knuckle clearance from the work surface. Square forged tang and chromed ferrule hold blade securely to prevent twisting. Capped handle prevents splitting when used for levelling bricks. London pattern smooth rounded wooden handle with integral tang.

Clamp Heads

M130
A low cost alternative to a full size sash clamp. Clamp heads have a cast grey iron head and slide with a steel main screw. Clamp heads are designed to be fitted to a wooden batten 25mm (1") thick by 38mm (1") wide and any length.

Rutland™ Planting & Weeding Tools

Hammered epoxy coated carbon steel blade. Varnished wooden handle. 285 x 80mm.

Carbon Steel Forks & Trowels

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.