Open Jaw Spanners

Made from forged and hardened steel. Conform to DIN 895.

Double Ended

Swivel End Socket Wrenches

Designed to give greater flexibility and improved access when working in difficult conditions. Bi-hexagon (12 point). Manufactured from fully polished chrome vanadium steel. Conform with ANSI B107.5M.

Kennedy Multibender Pipe Tool

Precision bending up to 180 on copper and thin wall steel tubing. Bends tube without distortion. Formers and guides will accept 12, 15 & 22mm O/D tube. For use in the plumbing, heating, refrigeration and air conditioning industries.

36 LED Inspection Lamp with Swivel Clamp Car Battery Powered

Ideal for use in engine bays and other low light work areas
Attaches to the car battery using clips allowing for use in remote areas
Ball-jointed swivel clamp gives maximum positioning versatility
Convenient grip mounted
ON/OFF switch
4.8m power cable
Oil, petrol and UV resistant
Rubber handle
Hanging loop

SiteSafe® Contractor Cold Chisels

SiteSafe® Contractor cold chisels are available as flat chisels, cross cut chisels, brick bolsters and electricians' floor chisels. They are all manufactured from high strength octagonal section chrome vanadium steel with ground cutting edges.

Conform to BS3066.

Contractor Brick Bolster Chisels

SiteSafe® Contractor brick bolster chisels used for splitting bricks.

Kennedy Hexagon Key L-Wrenches

Manufactured from fully hardened carbon steel in accordance with DIN 911 ensuring a quality ductile key with precision square cut ends and accurate AF dimensions to ensure full socket contact. Black finish.

Metric

SiteSafe® Contractor Flat Cold Chisels

Manufactured from high quality octagonal chrome vanadium steel with a ground cutting edge, in accordance with BS 3066. For use on brickwork, masonry and cold metals.

Thor Soft Faced Hammers

A safer alternative for striking machined surfaces than conventional steel hammers. The impact resistant striking faces shape themselves to the component being struck, minimising rebound damage to the component and reducing noise pollution in the work place. The striking faces can be easily replaced once they have become worn. Available as standard, with a choice of 5 interchangeable face types:

Rawhide Face

Head manufactured from malleable iron fitted with two rawhide striking faces and solid wooden handle. Rawhide manufactured from genuine water buffalo hide, tightly coiled and pressed three times under powerful hydraulic presses to ensure uniform quality and maximum durability.

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Flat Chisel

Used by the engineering and building trades for cutting and chipping cold metals, brick work and stone. The angle of the cut edge should be 60 - 70, inclusive, but is dependant on the material to be cut. When cutting metal, the softer the material is, the more acute the cutting angle should be.

Double-Ended Ring Spanners

Made from chrome vanadium steel with a satin finish body and highly polished heads, with double ended closed jaw bi-hexagon offset. Conform to DIN 838, BS 192 : 1982 & BS 3555 : 1998.

Whitworth