Open Jaw Slogging Wrenches

Manufactured to DIN 133.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.

Kennedy Plumbers Tools

The Kennedy Rubber Strap Wrench is a very versatile tool it is easy to use, even in confined areas.

Position the tool as required and then pull the strap through until its tight around the filter, pipe etc. The handle bites into the strap’s outer edge to give excellent grip when under load. When released, the grip loosens off allowing easy repositioning and fast progress.

Typical tightening/loosening applications:
Plated & Brass taps.
Oil filters.
Radiator connectors.
Pipework.
Jars.
Hold irregular shapes.

Rubber Strap Wrench

Capacity: 15-150mm diameter.

Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

Impact TX Bit Driver Sockets

1/2" sq. dr. Torx Drivers: T40, T45, T47, T50, T55, T60, T70.

Senator® 2 Blade Pocket Knife

With traditional style rosewood handle. Stainless steel blade and brass fittings.



Spear Point & Clipt Point.

Stencils

Stencils manufactured from hard wearing quality steel with precision cut letters for a clean sharp image. Suitable for use with all paints and marking compounds for marking packing cases with shipping details, loading/work bay walls for identification, car park spaces and countless other applications.

26 Piece Letter Sets A - Z

Sink Waste Cleaner

Suitable for unblocking domestic waste pipes including: sinks, baths and showers. All galvanised steel for resistance to rust. 2m body with gripping handle. Corkscrew end is for dislodging and moving any obstructions.

SiteSafe® Flexi Tub Builders' Bucket

Extremely versatile and virtually indestructible. Can be used for mixing plaster or cement, moving rubble and various other jobs around a building site. Available in 26, 40 & 75 litre capacities, in a choice of blue or yellow.

Short Arm Ratchet Combination Spanners

Manufactured from hardened chrome vanadium steel with a polished mirror finish. Conforms to ANSI 8107.6.

Split Collet Internal Bearing Extractors

The collets are precision machined, ideally used with sliding hammer assembly. For removing gears, bearings, pinions, oil seals when conventional pullers cannot be used. Collets close down to allow passage through a bore and then "wind" out to grip the blind side of the component.

Kennedy Crowbars, Wrecking bars and Pry bars

Manufactured from square section Chrome Vanadium steel with ground points. Impact resistant plastic handles offer a more comfortable and secure grip to make these pry bars the most user friendly available. Handles are oil and acid resistant. Suitable for a wide range of general duty applications within the packing, automotive, maintenance and assembly industries. Ideally suited to most tradesmen.

Curved Blade

For general duty prising and levering. The curved blade will provide greater leverage.
Set contents:
3 piece: 1 of each 300mm Straight, 300mm & 450mm Curved
2 piece: 1 of each 450mm & 600mm Curved