Industrial Open Ended Spanner Sets

Made from chrome vanadium steel with a satin finish body and highly polished heads, with a 15 offset. Conform to DIN 3110 & BS 192 : 1982.

8 Piece Metric

Contents: 24 x 26, 25 x 28, 27 x 30, 27 x 32, 32 x 36, 36 x 41, 41 x 46 & 46 x 50mm.

1/4" AF Hexagon Drive Screwdriver Bits

All Kennedy screwdriver bits have a hardness of 58 - 62HRC. High alloy chrome molybdenum steel for use on hand and power tools.

Square

Kennedy Cases - Accessories

NB: complete case is shown for illustration only. Case, contents and tools are not included.

Kennedy 40" Box Section Spirit Level (1m)

Industrial quality with three factory set vials, 1 horizontal and 2 plumb, aluminium body with 1 milled working face. Powder coat finish with plastic protective end caps and single hanging hole. Accuracy: 0.75mm/m.

Heavy Duty Trolley Jacks

Constructed from heavy gauge steel for heavy duty use with a large diameter saddle for a secure hold under the jacking point. Extra long handle for easy access under bigger vehicles which also tilts and locks in three positions with a built in handle mounted safety release to prevent accidental lowering of the load. A foot pedal pump and fine adjustment are fitted on the handle for optimum vehicle height. Automatic safety overload protection and rear toe plate for easy positioning.

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

Brake Clip Tool

Removes and replaces T-slot anti-rattle spring washers found in drum brake assemblies. Hardened and tempered carbon steel shank and cup with oxidised finish for protection against corrosion, bevelled and notched cup fits 16 - 22mm (5/8" - 7/8") diameter. Impact resistant square section handle for secure grip even when greasy.
Overall length: 152mm (6").

Ball Driver L-Wrenches

Manufactured from fully hardened carbon steel in accordance with DIN 911. A quality ductile key with precision cut ends and accurate AF dimensional to ensure maximum socket contact. Ball end allows up to 30 work offset. Long arm end is ball drive and short arm end plain. Black oxidised finish.

Replacement Nozzles for Industrial Lazy Tong Riveter

To suit KEN-569-3020K/-3040K.

Open Jaw Slogging Wrenches

Manufactured to DIN 133.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.