Kennedy Drain Rods

The Kennedy double worm screw for Kennedy drain rods pierce blockages such as paper or rags and the obstruction is drawn back to clear the pipe.
Available with two different type of joints:

Universal: Rods fitted with this type of joint should only be rotated in a clockwise direction.

Lockfast: Rods fitted with this type of joint can be rotated in either direction and will remain secure in the most demanding conditions.

4?? Double Worm Screw ?Lockfast?

Spares and Accessories

To suit the Kennedy Drop Head Threader (KEN-588-8800K).

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Flat Chisel

Used by the engineering and building trades for cutting and chipping cold metals, brick work and stone. The angle of the cut edge should be 60 - 70, inclusive, but is dependant on the material to be cut. When cutting metal, the softer the material is, the more acute the cutting angle should be.

Cooks Knives

All Granton knives are available with a choice of red, blue, yellow, green, brown, white or black handles. This system helps prevent cross contamination by assigning coloured handles to particular work areas.



A cooks knife has a curved blade designed to 'rock' from handle to tip for a gentle, even rocking and gliding motion as you cut. Exceptionally safe wide blade is also great for scooping and gathering after cutting. Suitable for dicing onions and peppers, also makes slender "matchstick" French fries and thinly shreds cabbage. Use the whole blade to cut larger items or use the flat side of the blade to lightly smash the skins from garlic cloves.

Industrial Open Ended Spanners

Made from chrome vanadium steel with a satin finish body and highly polished heads, with a 15 offset. Conform to DIN 3110 & BS 192 : 1982.

Metric

Butane Soldering Torch

Cordless pocket sized soldering torch, butane powered - simple to refill. The gas fuel level can be seen clearly in the transparent 7ml tank. Textured anti-slip barrel, flint wheel in cap for ignition. Safety wire stand prevents the soldering iron from rolling when not in use. Can be used with hot knife, gas torch and deflector tips. Supplied with pointed soldering tip and without butane.
Power rating: 30W to 70W.
Soldering temperature: 210C to 400C.
Maximum temperature: 1300C.
Run time: approx 30 minutes (full tank of fuel at mid heat level setting).
Overall length with cap: 153mm
Overall length with soldering tip: 140mm.

Open Jaw Slogging Wrenches

Manufactured to DIN 133.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.

3/8" Square Drive Bi-Hexagon Sockets

Chrome vanadium. Bi-hexagon. (12 point). All have a ball-retaining groove on each face of the square drive, which ensures a positive fit with all 3/8" drive accessories.

AF Deep

Ring Slogging Wrenches

Manufactured to DIN 7444.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.

Hydraulic Pullers

Ram Extension Bars