Open Jaw Slogging Wrenches

Manufactured to DIN 133.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.

1/4" AF Hexagon Drive Screwdriver Bits

All Kennedy screwdriver bits have a hardness of 58 - 62HRC. High alloy chrome molybdenum steel for use on hand and power tools.

Tamperproof Torx

For repair and servicing on electronic, electrical and mechanical equipment.

Sash Brushes

Plastic handle. Ideal for cleaning out sawdust, swarf etc.
Sizes: No.6, No.8, No.610, No.12 and No.16,

Industrial Combination Spanners

Manufactured from chrome vanadium steel with a satin finish body and highly polished heads. 15 open jaw angle to shank and ring end offset.
Conform to:
5.5mm - 25mm, 1/4" - 1" AF - DIN 3113.
26mm - 95mm, 11/16" - 2" AF - ASME B107.6.
1/8" - 1/2" Whitworth - DIN 3113 & BS192:1982.
9/16" - 7/8" Whitworth - ASME B107.6 & BS192:1982.

Metric

Kennedy Multi-Stripper PLUS

The newly developed Multi-Stripper PLUS: Screwdriver, voltage tester, stripper for conductors, round and coaxial cables and cutter in only one tool.
Screwdriver;
Two Double Ended bits:
No1PZ & 8855; x 3.5 slotted
No2PZ & 8855;,x 4.0 slotted
Bit storage inside handle.
Voltage tester; 110-250 Volt.
Ergonomic dual material handle;
Round Cable Stripper ;
Capacity 8-13mm dia (eg NYM 3x1.5mm-5x2.5 mm).
Built-in side cutter;
For PVC-isolated round cables max. 9mm dia.
Coax Stripper;
Two or three-level stripping of all common coaxial cables of 4.8-7.5mm dia.
Wire Stripper;
For all common stranded and solid conductors 0.5mm (20AWG) to 6.0mm (10AWG).

Industrial Combination Spanners

Manufactured from chrome vanadium steel with a satin finish body and highly polished heads. 15 open jaw angle to shank and ring end offset.
Conform to:
5.5mm - 25mm, 1/4" - 1" AF - DIN 3113.
26mm - 95mm, 11/16" - 2" AF - ASME B107.6.
1/8" - 1/2" Whitworth - DIN 3113 & BS192:1982.
9/16" - 7/8" Whitworth - ASME B107.6 & BS192:1982.

A/F

Boat Level

Industrial quality with two factory set horizontal and angled vials which are shockproof to a tolerance of 1mm/m. Die cast zinc body with enamelled finish. V-groove on base.

Open Jaw Spanners

Made from forged and hardened steel. Conform to DIN 894.

Single Ended

Double-Ended Ring Spanners

Made from chrome vanadium steel with a satin finish body and highly polished heads, with double ended closed jaw bi-hexagon offset. Conform to DIN 838, BS 192 : 1982 & BS 3555 : 1998.

Metric

Artist Brushes

Plastic handle with pure bristles. Each brush is marked with
its size.