Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Cross Cut Chisels

Used for cutting keyways or flat bottomed grooves in blocks of steel or on steel shafts. The cutting edge is wider than the blade to give clearance in work and prevent jamming.

Heavy-Duty T-Handle Multi Hold Clamps

Manufactured from heat treated carbon steel for extra strength. Finished with nickel and chrome plating. Textured T-spindle for extra clamping force. Supplied with three replaceable clamping pads for versatility.

Chrome Molybdenum Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

BSW Deep

1/2? Drive BSW Size, Deep Length, 6-Point
Conform to: SAE, USA Federal Standard GGG-W-660A.

Internal Spring Calipers

Manufactured from high quality polished steel with ground finished points. A circular spring bow joins the legs and a fine adjusting screw is mounted across the legs and is used for setting the distance between the two points. Calipers are used for taking internal and external measurements, also for comparing distances or sizes.

Liquid Measures

Chemical and oil resistant polyethylene liquid measures.



Graduations:
1/4ltr - 10ml.
1/2ltr - 10ml.
1ltr - 10ml.
2ltr - 20ml.
3ltr - 50ml.
5ltr - 100ml.

3/4" Square Drive Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

AF

3/4? Drive Inch Size, Standard Length, 6-Point
Conform to: SAE, USA Federal Standard GGG-W-660A.

Replacement 3/4" Square Drive

For the Kennedy TN14 Torque Multiplier illustrated (KEN-555-4520K).

Chrome Molybdenum Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

AF Deep

1/2? Drive Inch Size, Standard Length, 6-Point
Conform to: SAE, USA Federal Standard GGG-W-660A.

Kennedy Phosphate Finish Adjustable Wrench Service Kits

Consisting of replacement jaw, knurl and pin.

Kennedy® Butane Soldering Iron Tips

Interchangeable tips for use with Kennedy® BS125 soldering iron.