1/4" Square Drive Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

Metric

Drawers/Dividers for Kennedy Small Parts Storage Cabinet Range

Drawers:
Small: (H)36.5 x (W)54 x (L)140mm
Medium: (H)59 x (W)140 x (L)140mm
Large: (H)59 x (W)280 x (L)140mm

Dividers:
Small: 50 x 29mm (Pk 10)
Medium/Large: 133 x 50mm (Pk 5)

Small Parts Storage Cabinet shown for illustration purposes (not included)

Knife Blades

To use in conjunction with the Kennedy 16 piece precision Knife Set

General Cutting & Slicing

1" Square Drive Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

Metric Deep

1? Drive Metric, Deep Length, 6-Point
Conform to: DIN 3129.

Zinc Plated Drum Tap

With 3/4" BSP male threads. Both models can be locked into the off position by use of a padlock or locking pin.

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Flat Chisel

Used by the engineering and building trades for cutting and chipping cold metals, brick work and stone. The angle of the cut edge should be 60 - 70, inclusive, but is dependant on the material to be cut. When cutting metal, the softer the material is, the more acute the cutting angle should be.

Chrome Molybdenum Impact Sockets

Impact sockets and accessories are manufactured from high quality chrome molybdenum steel. Black oxidised finish with permanent laser etched markings. Conform to: Metric DIN 3129, Imperial SAE USA Federal Standard GGG-W-660A.

BSW

1/2? Drive BSW Size, Standard Length, 6-Point
Conform to: SAE, USA Federal Standard GGG-W-660A.

Kennedy® Edge & Centre Finders - Cylinder Type

For fast accurate work location. Made from tool steel and hardened all over, they can be used on flat surfaces, straight edges, shoulders, grooves, studs, dowels, centre points and scribed lines.

Combination - Edge & Centre Finders

Kennedy Universal Ball Joint Remover

Manufactured from drop forged alloy steel with slim tapered fork jaw for easier access into confined areas. Suitable for use on most car and light commercial vehicle ball joints.

KENNEDY PROFESSIONAL BI-MATERIAL FILE HANDLES

These file handles have a polypropylene base with integral hanging hole, covered with a ribbed rubber grip for comfort and increased purchase.
Available in thre sizes:
Size O.
Size 1.
Size 2.