Kennedy Drain Rods

The Kennedy double worm screw for Kennedy drain rods pierce blockages such as paper or rags and the obstruction is drawn back to clear the pipe.
Available with two different type of joints:

Universal: Rods fitted with this type of joint should only be rotated in a clockwise direction.

Lockfast: Rods fitted with this type of joint can be rotated in either direction and will remain secure in the most demanding conditions.

4?? Double Worm Screw ?Lockfast?

Spares and Accessories

To suit the Kennedy Drop Head Threader (KEN-588-8800K).

Kennedy Cold Chisels

Kennedy cold chisels are manufactured from high quality, high strength octagonal section chrome vanadium steel with ground cutting edges. They are are used to channel brickwork, concrete, chip stone and to remove waste metal when a very smooth finish is not required or when the work cannot be done easily with other tools, such as a hacksaw, file, bench shears or power tools. The head of each chisel is chamfered to slow down the formation of the mushroom shape caused by hammering. Conform to: BS3066.

Flat Chisel

Used by the engineering and building trades for cutting and chipping cold metals, brick work and stone. The angle of the cut edge should be 60 - 70, inclusive, but is dependant on the material to be cut. When cutting metal, the softer the material is, the more acute the cutting angle should be.

Industrial Open Ended Spanners

Made from chrome vanadium steel with a satin finish body and highly polished heads, with a 15 offset. Conform to DIN 3110 & BS 192 : 1982.

Metric

Open Jaw Slogging Wrenches

Manufactured to DIN 133.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.

Ring Slogging Wrenches

Manufactured to DIN 7444.



Manufactured from forged and hardened steel with machined drive faces to ensure good contact with the fastener. With flat striking faces to allow hammer blows to be used to loosen or tighten stubborn fasteners.

Kennedy Hand Stamps

Drawn carbon steel nickel-plated hand stamps with chamfered edges to prevent accidental damage to workpiece.

Handle Assembly

To suit the Kennedy Heavy Duty Trolley Jack (KEN-503-6420K)

10mm AF Hexagon Drive Screwdriver Bits

All Kennedy screwdriver bits have a hardness of 58 - 62HRC. High alloy chrome molybdenum steel for use on hand and power tools.

Hexagon

Kennedy® Line Pins

Construction quality, hand, chrome plated line pins. Supplied in pairs. Use with Kennedy® brick line to create a horizontal line for consistent bricklaying without the need for repetitive levelling. Size: 150mm (6").