Instant Adhesive

General purpose, for metals.

496 Medium Viscosity.

Loctite 401 - General-Purpose Instant Adhesive

For bonding ceramics, aluminium, steel, leather, fabric and paper in seconds. Maximum operating temperature: 120°C. NSF P1 registered. Available in 3g, 20g and 50g.

Loctite 3295 Structural Adhesive

High strength two-part acrylic adhesive for structural bonding of a wide range of substrates including plastic and metals. The two components are applied premixed from the dispenser and cures rapid on assembly of the joint.

518 - Flexible Fast Cure Gasket

Recommended for sealing aluminium flanges and fills up to 0.5mm. Withstands fluctuations in pressure, temperature and vibration. Replaces pre-cut gaskets on rigid parts.

Loctite SuperFlex Silicone Sealants

Provides a solid rubber seal directly from a tube. Will not sag or slump during applications. Can be used to produce gasket seals up to 6mm thick. For use with all common engineering materials.

495 - Low Viscosity Instant Adhesive

Thin easy flowing general-purpose instant adhesive. Suitable for close fitting small components and parts bonding on rubbers, plastics and metals. Anvailable in 20g and 50g.

Loctite 275 High Strength Threadlocking Compound

Loctite 275 High Strength High Viscosity Threadlocking Compound

2701* Studlock Threadlocker

To replace interference studs etc. Also removes the need for blind holes for studs in oil filled castings. Requires light torque for removal. *Replaces 270.

Loctite Hysol 3475 A&B - Metal Set A1 - Slow Cure

Loctite Hysol 3475 A&B is an aluminium filled, 2K-Epoxy adhesive, for repairing and rebuidling worn metal parts. Ideal for repairing castings and cracks in housings and machine parts.

Typical Properties
? Mix ratio by volume: 1:1
? Mix ratio by wight: 100:100
? Working life: 45 min.
? Fixture time: 180 min.
? Colour: Grey
? Viscosity: Putty
? Shear strength (GBMS): 20 N/mm
? Compressive strength: 70 N/mm
? Operating temperature: up to 120C

515 Gasket Eliminator

Flexes with minor flange movement. Fills gaps up to 0.25mm. Does not shrink or migrate. Temperature range -55C to 150C. AGA approved No. 2590 up to 6900kPA (100psi).