770 Polyolefin Primer

Materials such as polypropylene, polyethylene, and thermoplastic rubber are normally difficult to bond. This material makes them suitable for bonding with Loctite cyanoacrylate adhesives.

Loctite 9466 A+B Dual Cartridge

Loctite Hysol 9466 A&B is a toughened, 2K-Epoxy adhesive, suitable for multi purpose applications requiring long open time and high bonding strength. Ideal for a wide variety of substrates like metals, ceramic and most plastics.

Working time: 60min.
Fixture time: 180min.
Viscosity in Pa-s: 35.
Tensile strength: 32N/mm².
Peel strength: 8N/mm.
Service temperature range: -55°C - +120°C.
Colour mix: off-white.
Pack sizes: 50ml, 400ml.

222 Screwlock Threadlocker

Low strength, replaces nylon/star/spring washers on screws and threaded fitting where easy dismantling is required, e.g. with a screwdriver. NSF P1 registered.

243* Nutlock Threadlocker

Medium strength. Works on all metals including chrome free platings, Improved temperature resistance (180C) and heat aging, improved oil tolerance, Prevents loosening on parts such as pumps, motor mounting bolts, gearboxes or presses.

510 - Flange Sealant

Recommended for high temperature applications (up to 200C), where maximum solvent resistance is required.
AGA approved No. 2590 up to 6900kPA (100psi).

641 - Bearing Fit

Medium strength for use with parts that will require subsequent dismantling using ordinary tools. Prevents fretting and corrosion.

Instant Adhesive

Standard: Household size instant adhesive for bonding metals, rubber, plastic and most non-porous materials in seconds.

Super Glue

Loctite 401 - General-Purpose Instant Adhesive

For bonding ceramics, aluminium, steel, leather, fabric and paper in seconds. Maximum operating temperature: 120°C. NSF P1 registered. Available in 3g, 20g and 50g.

326 - Rapid Cure Structural Adhesives

For joining flat faces of rigid, close fitting metal and glass. Moisture and solvent resistant.

518 - Flexible Fast Cure Gasket

Recommended for sealing aluminium flanges and fills up to 0.5mm. Withstands fluctuations in pressure, temperature and vibration. Replaces pre-cut gaskets on rigid parts.