290 - Penetrating Threadlocker

High strength, post application with very low viscosity. Vibration proof. WRC approved.

7063 - Cleaner

General purpose industrial cleaner for cleaning and degreasing surfaces to be bonded with adhesives. Its ready-to-use formula dries residue free and is compatible with metal, glass, rubber, most plastics and painted surfaces. It will not cause flash rusting on water sensitive parts. Contains no ozone depleting compounds. Recommended as a final pre-assembly cleaning treatment for all surfaces bonded with adhesives.

Activator Kit

50ml Tube with 40ml Aerosol of 7388 Activator.



20251 - (with 25gm 7387 activator)
This multi-purpose adhesive suits bonding needs including metal bonding, ID plates and signage. Two part no mix, fast curing and toughened with good moisture, impact resistance and peel strength.
(50ml kit includes 7387 activator 25mg).

620 - Hi-Temperature Adhesive

A single component anaerobic adhesive which cures between metal surfaces where air is excluded. A secondary heat cure is required to generate the high temperature resistance up to 200C.

Activators for Thread & Gasket Sealants

7649N - Recommended for use when a very fast cure is required. 7471T - Recommended for use at below 15C or on inactive surfaces.

Loctite SuperFlex Silicone Sealants

Provides a solid rubber seal directly from a tube. Will not sag or slump during applications. Can be used to produce gasket seals up to 6mm thick. For use with all common engineering materials.

5800 Medium Strength Gasketing Sealant

LOCTITE® 5800 is a single component, medium strength, anaerobic sealant which cures when confined in the absence of air between close fitting metal surfaces. Typical applications include sealing close fitting joints between rigid metal faces and flanges. The product provides resistance to low pressures
immediately after assembly of flanges. Typically used as a form-in-place gasket on rigid flanged connections, e.g. gearbox and engine casings, etc.



Benefits:
• Leading in Health & Safety
• No hazard symbols, no risk phrases & no safety phrases
• “White” Material Safety Data Sheet – no entries in sections
2, 3, 15 and 16 of MSDS acc. to (EC) No. 1907/2006 – ISO
11014-1
• Excellent chemical and thermal resistance of cured product

Technical Data:
• Colour: Red
• Service temperature range: -50°C to +180°C
• Tensile shear strength: 12 N/mm²
• Max. gap: 0.3 mm
• Max Fixture time steel: 25min.
• Strength: Medium
• Cure method: Anaerobic
Pack size: 50ml

7240 Activator

Increases cure speed on passive and inactive surfaces. For large bond gaps. For low (<5°C) temperature curing.

Instant Adhesive

A high viscosity ethyl cyanoacrylate adhesive for general- purpose bonding of rubber, plastic and metal. Replaces 415, 416 and 422.

431 - High Viscosity

2701* Studlock Threadlocker

To replace interference studs etc. Also removes the need for blind holes for studs in oil filled castings. Requires light torque for removal. *Replaces 270.