518 - Flexible Fast Cure Gasket

Recommended for sealing aluminium flanges and fills up to 0.5mm. Withstands fluctuations in pressure, temperature and vibration. Replaces pre-cut gaskets on rigid parts.

270 High Strength Threadlocker

Works on all metals including chrome free platings, Improved temperature resistance (180C) and heat aging, improved oil tolerance. High strength locking of studs and bolts where removal is not required. Available in 10ml, 50ml, 250ml and 2ltr.

574 - General Purpose Flange Sealant

Conforms with BS6920 (potable water). General purpose flange sealant for gaps up to 0.5mm. Typical applications are hydraulic and pneumatic control valves, transmission and engine flanges and marine pipework.
Suitable for 90% of flange sealing applications.

268 High Strength Thread Locking Compound

High Strength Thread Locking Compound in a convenient clean and easy to use stick form. As with other Loctite high strength thread locking products, it locks the threads to resist vibration and also completely seals the threads against most industrial fluids.

Metal Set Syringe

A two-part filled epoxy resin supplied in a small hand held dual syringe giving accurate dispensing for small scale repairs.

Loctite 4062 - Instant Adhesive / Ultra Fast Curing

Ideal for highest speed bonding of plastic, metal and rubber. Use with 770 polyolefin primer for difficult to bond plastics. Perfect for bonding material to lampshade frames, bonding small plastic ornaments/symbols to plastic base, rubber strips to clamp faces, rubber end pieces to plastic tubes and high strength locking of plastic fasteners. Replaces 420 and 493. Available in 20g or 50g.

Specifications: operating temperature up to 80°C.
Fixture time (on steel): 3-20sec.
Viscosity mPa.s: 2.
Especially for metal/plastics.

High Strength Threadlocker

Medium and high strength threadlockers that once cured offer excellent resistance against most industrial chemicals. They achieve good thermal resistance, withstanding continuous operating temperatures up to 150C. Both of these products retain the customary high Loctite performance with a "white" bill health and safety bill meaning no hazard symbols, no risk phrases and ultimately no need for COSHH assessment.

N.B. 2400 (medium strength) and 2700 (high strength) threadlockers illustrated.

2700

2700: High strength threadlocker that is fluorescent green with a viscosity of 500 mPa?s and a shear strength of 18N/mm.

572 - Thread Sealant

Recommended for all coarse threads where slow cure is required to allow final adjustment before sealing. Meets BS 6956 Type A for sealing gas fittings. WRC approved for use with potable water.

511* - Thread Sealant

Seals and locks in any position. Low strength and easily dismantled. Contains teflon to prevent galling. *Fast cure version of 572. Conforms with:BS 6956 : 7 (gas). Crries the German DVGW approval. tested in accordance with EN751-1. Certified to NSF P1.

5331 - Threadsealer Sealant

Recommended for use on threaded plastic or plastic/metal fittings carrying hot or cold water e.g. industrial and agricultural plastic water pipe systems, or drainage systems.
WRC approved to 85C (Potable Water)
P1 NSF Reg. No:123620